- Cut out base; Note that the rectangle labeled "Fold down" is to be cut on three sides and scored on one, then folded down to provide a mount for the crankshaft.
- Drill holes where indicated large enough for dowel to pass through and rotate freely
- Score and bend on dotted lines
- Fold base into an open box shape and glue corner tabs in place. Tabs should be glued to the inside of the base.
- Cut out crossbeams (2). Drill holes where indicated large enough for dowel to pass through and rotate freely. Score and bend on dotted lines. Then fold and glue on the beams to the underside of the base, using the arrows to position them properly. One of the beams should be gluded to the crankshafl mount (the rectangle folded down from the base). The tabs with the arrows should be folded over the crossbeams and glued into place
- Cout out legs, first studying the illustration carefully so that you can understand how the inner section is to be cut, scored and folded. Lines marked like this <INSERT IMAGE HERE> should be scored on the reverse side.
- Fold legs as shown and glue to corners of the base. Glue the edges of the base to the inner sections of the legs. This will increase the strength of the legs.
»
- Login to post comments