- Cut out frame
- Drill hole in top, just large enough for wire to fit through snugly. Drill two holes in bottom. These holes should be large enough for rubber stripping to fit through. Start drilling holes with a hobby knife and enlarge with the point of a pencil
- Score and bend on dotted lines
- Fold the frame into an open box shape. Glue corner tabs in place. Glue end glaps over long side tabs
- Apply two or three drops of super glue to the hole drilled in the top of the frame. Let the glue dry completely. Then redrill the hole, making it just large enough for wire to fit through snugly. Sand lightly to remove the rdige around the hole. This treatment ill create a smooth, low-friction surface against which the washer attached to the rotor shaft will turn.
»
- Login to post comments