- Insert a straight pin through the top part of the pedestal as
shown. Pin should pass between the pedestal layers. The sharp point of
the pin should extend ¼ of an inch from the top of the pedestal. Check
to make sure pin is positioned properly, then clip away the lower part
of the pin. Place a drop of super glue on the lower part of the pin to
keep it from slipping out of the pedestal. - Balance the plane
on the pedestal by placing the tip of the tail that extends to the rear
of the fuselage onto the sharp point of the pin. Adjust until thep lane
balances in a level position. Once you have found the balancing point,
press down so the ping make a small indentation in the underside of the
plane. Use a pencil point to deepen the indentation slightly. This will
help hold the plane in place and will make it easy to locate the
balancing point whenever thep lane is re-installed on the base.
»
- Login to post comments