- Cut out cab, dashboard, upper windshield panel, an top of cab. If you are planning to use the cab of your truck as a pencil holder and have selected a cut-out decal when customizing your truck, use a hobby knife to cut out the center section of the cab top.
- Score and bend on the dotted lines.
- Fold cab into an open box shape as shown. Glue tabs in place.
- Glue dashboard and upper windshield panel, curved edge up, into place at front of cab as shown.
- Cut two pieces of doweling, 2½ inches long. These will be windshield posts.
- Apply white glue to both ends of the posts and slip in place at front inside corners of cab. Twist dowels to spread glue. Hold in place until glue has set, being careful to keep the cab assembly square.
- Gently curve the top of the cab to match the curve in the windshield and back of cab. Then glue the top of cab in place, allowing an equal amount of overhand on all sides.
»
- Login to post comments