- Cut out fenders.
- Drill holes where indicated. Holes should be just large enough for wire to pass through and rotate freely.
- Score and bend on the dotted lines. Lines marked like this <INSERT IMAGE HERE> should be scored on the reverse side.
- Fold
each fender as shown, gently curving the part that will fit over the
wheel by pulling it over the sharp edge of a desk or table top. Glue
tab in place. - Glue fenders to truck as shown. The running
board section should be glued under the cab and the fender section
should be glued to the front chassis. The straight forward edge of the
fender should be flush with the straight forward edge of the chassis. - When glue is dry, redrill holes for front axles.
»
- Login to post comments